New gas level sensor PW3 is available. The sensor is fully compatible with PW1 and PW2 sensor. In the program, select the sensor KME PW. Indication of gas is stable. The tip indicates the level of gas always even without power. The sensor is waterproof.
On the market there are engines without vacuum in intake manifold (like valvetronic type: BMW, VOLVO). In this engines can be difficult to make proper calibration of sequential gas injection system. For easy and proper calibration it is necessary to use PPO converter. Device generates the load signal for the gas injection system DIEGO according to air flow meter. Small dimensions and hermetic enclosure allows for mounting the device in the engine chamber where the device can be exposed to weather conditions. Small dimensions and hermetic enclosure allows for mounting the device in the engine chamber where the device can be exposed to weather conditions. Connection diagram and manual is available after login in section.
Communication interface for KME gas systems (NEVO, DIEGO and BINGO).
Enables wireless connection to KME systems (NEVO, DIEGO and BINGO, etc.) via Bluetooth.
Gas level sensor for multivalve: Tomasetto. PW2 gas level sensor have 5 diodes (full compatible with sensors: AEB1050, EMER 1D).
OBD Adapter v2 enables access to OBDII system in the car for Diego and NEVO system. Additionaly can be used like skaner OBD without gas system. Adapter OBD v2 offer: â€¢ reading from the OBDII system and its visualization in the Diego and NEVO software â€¢ read and control (including deleting) stored and pending trouble codes in petrol ECU, â€¢ Automatic adjustment and adaptation of the gas system using the corrections reads from the OBD (onlywith Diego system in version 3.0H or newer). Additionaly Adapter OBD v2 can be used like skaner OBD without gas system. It is possible to use it only for the calibration time - in this case calibration is easyer and you have more information from the car petrol system. It is also possible to mount it permanently in the car - then it serves as an interface between the petrol and gas controller and allows information for adaptive correction. OBD Adapter v2 can be used in cars with gas installation with NEVO gas controller. Adapter OBD v2 can be used in cars with gas installation with Diego families 1.4x, 1.5x and 3.0x. Controller in the 3.0H or later versions provide full cooperation with the adapter, including the adaptive functionality adjustments based on the OBD. Older gas controller versions only provide the functionality of the OBD scanner (reading parameters, troubler codes). The adapter can be connected to the OBDII using protocols that are used in most new European cars: â€¢ ISO9141, â€¢ KWP2000slow, â€¢ KWP2000fast, â€¢ CAN_11bitID_500kbps, â€¢ CAN_29bitID_500kbps, â€¢ CAN_11bitID_250kbps, â€¢ CAN_29bitID_250kbps. OBD Adapter v2 replaces version v1 (OBD Adapter v1 only works with DiegoG3).